Problem with Banner Stack

[carp-enter]

Hello everyone,

I have a problem in the Rapidweaver community that I thought was a RW problem. It turns out that the error only occurs with Foundry’s banner stack.
I assume Foundry designers are more likely to read along here, I’ll just link the issue here.

Partial is not displayed in edit mode | RapidWeaver Community

For me, I fixed the bug by not using the stack.

Greetings, Volker

[elixirgraphics]

If I’m understanding you then this is not actually a bug. Fixed height banners will crop the content as the height of the banner is not flexible in fixed height mode.

Here’s a post from 2016 where this is discussed:

Banner behaviour

[image] Adam is this normal, you can see I have set the heights of the banner, there are 3 columns in the banner but some are not accessible in this state

Another from 2019 as well:

Banner problems

This is likely because you’re using a fixed height for your Banner stack. This topic has been talked about in the past. Have a look at this thread here: I think that should help solve your dilemma. That said, I always think Fluid banner heights are best for responsive sites, IMHO.

My recommendation would be to use Fluid mode for banners. It is almost always a better solution.